The glazed tile cold roll forming machine can be devided in semi-automatic and fully automatic or chain molding machine and transmission box molding machine depends on the different areas.
mm
KN
m/min
The products of the production line are carried out according to the following technological process:
Uncoiling → cold bending molding → press table & cut off → discharge.
Roll forming unit of Glazed tile production line:
Purpose: It is used to achieve the desired interface shape through the roll bending process.
Structure: the forming unit adopts motor, reducer and reducer drive.
Forming machine archway for independent archway structure (not plate structure), stable performance, reliable, high precision.
Lower shaft drive, if necessary lane up and down shaft using synchronous gear.
The base is welded steel structure. Annealing after welding.
The forming roller is designed by professional software. The material is made of high quality 45 steel and hard chrome plating.
Equipped with 1 set of rollers.
Parameters: molding times: 16 (subject to the final design)
Shaft diameter of molding machine: φ70
Motor power: 5.5KW
Maximum linear speed: 2~5m/min
used to achieve the final required interface shape through the roll bending process.
Material | Galvanized sheet |
Yield strength of raw materials | ≤235Mpa |
Tensile strength of raw materials | ≤550Mpa |
Outer Diameters of Coils | ≤Ф1300mm |
Inner Diameter of Coils | Ф508 |
Steel strap width | ≤1500mm |
Steel Strap Thickness | 0.3~0.6mm |
Weight/Coil | ≤10000 kg |
PLC: Mitsubishi Inverter: Delta Touch screen: Vinylon (Taiwan, China) Low-voltage electrical appliances: Schneider (France) Encoder: Omron (Japan)
The forming unit adopts motor, reducer and chain drive.The arch of the molding machine is an independent arch structure (non-plate structure), with stable performance, reliability and high precision. The lower shaft is driven, and the upper and lower shafts use synchronous gears when necessary. The base is a steel welded structure. Annealing after welding. The forming roll is designed by professional software, and the material is high-quality 45 steel, plated with hard chrome. Configure 1 set of rolls.
It is to press the formed parts and cut them to length. Stop shearing. Mainly composed of shearing frame, cutting die, hydraulic system, base, etc. The cutter mode adopts nothing but material cutting.
Copyright © Shandong Raintech Group All Rights Reserved. | Privacy Policy | Powed by Yandex